If the hot end moves slower, it will be able to work with more detail. Keep in mind that with increasing speed you will have to expect losses in terms of quality. The challenge in this case is to balance print quality with the processing time per job. Without a doubt, speed is an important factor for a respectable result. An average temperature of 70☌ has proven to be best. On the one hand, this will counteract excessive cooling and prevent layer splitting and warping.Ī slightly higher temperature should be selected for PETG than for PLA. You should also consider building an enclosure. In this case, it is recommended to set the printing bed temperature at 110☌. The situation is different if you use ABS. As a guideline, you should remember that the temperature of the printing bed should always be higher than room temperature. You can do without heating the printing bed even if you already use an additive for adhesion such as glue, painter’s tape or hairspray. However, the material can still benefit from a little heat – as a guideline you should remember 50☌. (source: Ultimaker Cura) Why the Printing Bed Temperature is ImportantĪttention must also be paid to the material with regard to the printing bed temperature.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |